
Recherche avancée
Médias (1)
-
Rennes Emotion Map 2010-11
19 octobre 2011, par
Mis à jour : Juillet 2013
Langue : français
Type : Texte
Autres articles (67)
-
Gestion générale des documents
13 mai 2011, parMédiaSPIP ne modifie jamais le document original mis en ligne.
Pour chaque document mis en ligne il effectue deux opérations successives : la création d’une version supplémentaire qui peut être facilement consultée en ligne tout en laissant l’original téléchargeable dans le cas où le document original ne peut être lu dans un navigateur Internet ; la récupération des métadonnées du document original pour illustrer textuellement le fichier ;
Les tableaux ci-dessous expliquent ce que peut faire MédiaSPIP (...) -
Publier sur MédiaSpip
13 juin 2013Puis-je poster des contenus à partir d’une tablette Ipad ?
Oui, si votre Médiaspip installé est à la version 0.2 ou supérieure. Contacter au besoin l’administrateur de votre MédiaSpip pour le savoir -
Des sites réalisés avec MediaSPIP
2 mai 2011, parCette page présente quelques-uns des sites fonctionnant sous MediaSPIP.
Vous pouvez bien entendu ajouter le votre grâce au formulaire en bas de page.
Sur d’autres sites (9392)
-
Revision a76caa7ff4 : Alter Speed 3. This patch deletes the variance based speed three partitioning.
19 septembre 2013, par Paul WilkinsChanged Paths :
Modify /vp9/encoder/vp9_encodeframe.c
Modify /vp9/encoder/vp9_onyx_if.c
Modify /vp9/encoder/vp9_onyx_int.h
Alter Speed 3.This patch deletes the variance based speed three partitioning.
Speed 3 now uses the same partitioning method as speed 2
but with some stricter conditions.The speed and quality are now somewhere between speeds 2 and 4
whereas before it was worse in both than speed 4.Change-Id : Ia142e7007299d79db3ceee6ca8670540db6f7a41
-
Revision fe5e2a91bb : Auto min and max partition size experiment. Speed feature experiment to set an
24 juillet 2013, par Paul WilkinsChanged Paths :
Modify /vp9/encoder/vp9_encodeframe.c
Modify /vp9/encoder/vp9_onyx_if.c
Modify /vp9/encoder/vp9_onyx_int.h
Auto min and max partition size experiment.Speed feature experiment to set an upper and lower
partition size limit based on what has been seen
in spatial neighbors.This seems to gives quite reasonable speed gains in local
(10-15%) and when used with speed 0 the losses are small
(0.25% derf, 0.35% stdhd). However, for now I am only
enabling it on speed 1 as there may be clashes with the existing
temporal partition selection in speed 2.Using a tighter min / max around the range derived from the
neighbors increases speed further but at the cost of a
bigger quality loss. However, I think this spatial method could
be combined with data from either the last frame or a variance
method (or both) to refine the range of minimum and maximum
partition size. I.e. consider the min and max from spatial and
temporal neighbors and the variance recommendation.Change-Id : I1b96bf8b84368d6aad0c7aa600fe141b4f07435f
-
Revision 302698fb12 : Reworked the auto_mv_step_size speed feature This patch modifies the auto_mv_st
12 juillet 2013, par Deb MukherjeeChanged Paths :
Modify /vp9/encoder/vp9_block.h
Modify /vp9/encoder/vp9_encodemv.c
Modify /vp9/encoder/vp9_onyx_if.c
Modify /vp9/encoder/vp9_onyx_int.h
Modify /vp9/encoder/vp9_rdopt.c
Reworked the auto_mv_step_size speed featureThis patch modifies the auto_mv_step_size speed feature to
use a combination of the maximum magnitude mv from the last
inter frame, and the maximum magnitude mv for the two reference
mvs with the same reference. For arf frames, the max mav step
for the resolution is used.
The bounds therefore are slightly tighter. The feature is made
a speed 1 feature.Rebased.
Results (when this feature is turned on over speed 0) :
derfraw300 : -0.046% psnr, about 5+% speedup
(tested on football : goes from 4m30.760s to 4m17.410s).Change-Id : If492797a61b0b4b3e58c0b8f86afb880165fc9f6